位移

The relative displacement between the front and retral loading location is emphasized.

着重研究了前后油缸加载点的相对位。

Evaluations on the displacement of gnathion and gonion under different loads were made.

结果位量与加载力值成线性关系。

Piezoceramics telescopic micro-actuator was used in design of micro-gripper of robot.

机器人微操作手设计采用压电伸缩陶瓷微位器。

In caner to consider the characteristics of crack in transverse-force-transfer, the displacement-boundary-unidimensional-search method is presented.

分析中为考虑裂缝传递横向力的特性，提出位一维搜索法。

Results Gnathion and gonion showed positive displacement on X and Y axes and negative displacement on Z axis.

颏顶点、下颌角点均现为X、Y轴向的正位,Z轴向的负位。

In order to minimize the measurement error,the contact surface contourgraph is designed based on vertical displacement scan.

为减小测量误差,设计了基于垂直位扫描的接触式面形貌仪。

Axisymmetric elasticity problem of cubic quasicrystal is reduced to a solution of a partial differential equation with higher-order by introducing displacement function.

本文通过引入位函数使得立方准晶的轴对称弹性问题化为求解一高阶偏微分方程。

PC is used to store and process the displacement data and faradic voltage data which are acquired by multi-function data-collecting card in the meantime.

通过多功能数据采集卡得位数据以及感应电压数据，用PC机实现数据的存储处理。

Rotational alignment of the trochlear component parallel to the epicondylar axis optimizes patellar tracking.25,26 Palpation of the epicondyles is difficult, particularly when using smaller incisions.

与上踝轴平行的滑车成分旋转位能使髌骨痕迹最优化25.26。上踝触诊很难，特此是使用小切口。

Do the same for rotations and scalings for each bone.Make sure not to add a rotation to a translation list, it will cause a bug.

对于每个骨骼的旋转和缩放动作重复操作，确保不要将旋转参数添加到位动作的列上，因为那样会导致出错。

Rising the temperature continuously , when it in the valves runs over the temperature of drainage, the detrusion of top material causes the port A close.

温度继续升高，阀内温度超过该阀感温元件所排水温度，顶杆的位使A口关闭。

A method based on the resistance-displacement relationship of shape memory alloy(SMA) spring that can adjust the nonaxiality of small-diameter pipe inner surface inspection sensor is proposed.

根据记忆合金(SMA)弹簧的电阻和回复位一一对应的特性,提出了一种微细管道形貌检测器对中方法。

Based on the double refraction principle of outgoing beam in the biprism,the displacement method for measuring the small angle of biprism is presented.The error of this method is also discussed.

利用双棱镜引起出射光束方向双向偏折的原理,提出了一种位法测量玻璃双棱镜微小底角的新方法,介绍了测量的基本原理,讨论了测量误差.